XH-W1209 Temperature Controller Switch Module (ডিম ফুটানোর মেশিন )

Digital Temperature Controller XH-W1209

Product description

This thermostat is controlled by S T chip, digital display, easy to view High accuracy temperature control probe, excellent temperature control performance and precision. Wide temperature control range, simple setting, can be directly installed or embedded on the panel such as industrial control equipment, easy to use. The temperature control range is -50℃~110℃, control accuracy is 0.1℃ It is widely used in machine case temperature control, poultry incubation, air conditioning system, temperature protection and other occasions.

Specification:

1. Model: XH-W1209
2. power supply voltage: 12 v
3. Operating temperature: – 50℃~ 110℃
4. Temperature control accuracy: 0.1℃
5. Measurement input: NTC10K/B3950
6. Probe type: relay output 10A
7. Refresh rate: 0.5 seconds
8. Main board power consumption:Static current ≤35MA, pull current: ≤65MA
9. Weight: Approx.20g/0.7oz

Package list:

1 x Digital Thermostat Module

1 x sensor

Under normal power, press and hold the + and – key for about three seconds to restore factory settings.

1. PO temperature control mode:

This value must be set when the thermostat is used for the first time. If it is used for heating, it must be set to H. If it is used for cooling, it should be set to C.

2. P1 difference setting:

Press the SET button for a long time to enter the internal settings, select the P1 setting, and then press the SET button again to set the hysteresis value. (The hysteresis is the difference needed when the thermostat reaches the set temperature and stops working again.)

3. P2 temperature calibration:

This function is used for temperature calibration. If there is a deviation between the detected temperature and the actual temperature, this function can be used to correct. The corrected value = measured value + correction value. (If you do not control the compressor or do not need delay function, skip this item directly)

4. P4 high temperature alarm:

Set the high temperature alarm value. When the real-time temperature exceeds this value, the screen will flash warning alarm.